Sometimes this is done with one selection (with “Off” being an option for the tone frequency). This is normally a two-step process: set the tone frequency and then enable the tone.
(CTCSS is Continuous Tone Coded Squelch System.) Repeaters with carrier access do not require a tone, so you can skip this step. Tone – For most repeaters, you will need to transmit a CTCSS tone to access the repeater.
You can verify that your radio is programmed correctly if you see 447.725 MHz displayed during receive, which should change to 442.725 MHz when you push the transmit button. So you would enter 447.725 MHz into your radio, make sure the offset is set to 5 MHz and select – as the offset direction. Usually a + or – symbol will appear in the display to indicate the offset selected.Īs an example, my repeater is on 447.725 MHz with a – 5 MHz offset. Most radios will default to the standard offset but you may have to select + or – offset. Your repeater directory will list the offset and direction. In most parts of the US, the standard offset is 600 kHz on the 2m band and 5 MHz on the 70cm band, and can be either in the positive (+) or negative (-) direction. Your transceiver will automatically shift your frequency when you transmit, if you have the right offset programmed. This is the difference in frequency between the repeater transmit frequency and its receive frequency. Offset – Next, we need to make sure the proper transmit offset is programmed into the radio. Repeaters are always referred to by their transmit frequency, which can be found in an online or printed repeater directory. The frequency you enter is the repeater transmit frequency which will be your receive frequency. The actual key strokes or knob turns will depend on the particular model of radio so consult your operating manual.
Ham radio deluxe failed to read frequency software#
Using the programming software (and suitable cable) for your radio can be a big help.įrequency –First you need to program in the frequency of the repeater you want to access. You might not need to check all of these things in that exact order but it is a good way to approach the problem. To access a repeater you need to have its Frequency entered into your radio, have its transmit Offset set correctly and have the right CTCSS Tone turned on. The key things we have to pay attention to are: Frequency, Offset and Tone ( FOT). Many times the problem is due to not having the transceiver programmed correctly. For this article, I am assuming that your first rig is a handheld vhf/uhf transceiver but the general approach will work with mobile or base transceivers, too. However, in this article we’ll talk about some basic troubleshooting steps to help diagnose the problem. There can be a whole bunch of reasons why you can’t get into a repeater so it is difficult to come up with a quick fix for all situations. One question we often hear from new hams (and maybe some not-so-new hams) is “why can’t I get into the repeater?” They get their hands on a new radio, set it up to use one of the local repeaters and it’s not working. 47 Configuring.48 Connecting.49 Remote Connection. 43 OH2AQ / Ham Radio Deluxe.43 Custom DX Cluster Client.43 Starting.42 Configuration.43Ĭluster Source.
40 Top Window.40ĭX Cluster 41 Introduction. 40 Set Button.40 Set Dropdown.40 Set Frequency. 33 ICOM Calibration.34 Info: Modes.34 Info: Options.35 Internet.36 Out Of Band.36 Mouse Wheel. 23 Layout.24 Buttons.25 Faceplate.26 Frequency. 21 Band Selection.21 Date & Time.21 Buttons. 11įirst Steps 15 Connection.15ĭem-o-matic.15 Options. Introduction 7 How It All Began.7 This Guide.